Cafe C2Y366 Instructions D'installation page 13

7
4-WIRE POWER CORD
INSTALLATION (Cont.)
Insert the 3 terminal screws (removed earlier)
through each power cord terminal ring and into the
lower terminals of the terminal block. Be certain that
center lower position of the terminal block. Tighten
screws securely into the terminal block.
Before
Terminal
Block
Ground Strap
After
Terminal
Block
Ground
Screw
8
3-WIRE POWER CORD
INSTALLATION
NOTE: A 4-wire cord is connected to the range at the
factory. Use the following steps to change the range
to a 3-wire cord.
WARNING
The neutral or ground wire of the
power cord must be connected to the neutral terminal
located in the center of the terminal block. The power
leads must be connected to the lower left and the
lower right terminals of the terminal block.
of the terminal block) and connect between the
center lower portion of the terminal block to the
frame of the range.
31-2000815 Rev. 1
Installation
Ground Strap
or
Neutral
Terminal
Neutral Terminal
Ground Plate
(grounding to
range)
8
3-WIRE POWER CORD
INSTALLATION (Cont.)
terminal block. Insert the 3 terminal screws through
each power cord terminal ring and into the lower
terminals of the terminal block. Be certain that
center lower position of the terminal block. Tighten
screws securely into the terminal block.
DO NOT REMOVE THE GROUND STRAP
CONNECTION.
Ground
Plate
Power Cord
9
ROLL RANGE INTO POSITION
WARNING
The Anti-Tip Bracket must be
properly installed to prevent tipping of the range.
Failure to do so can cause serious damage or injury.
beneath the wheels.
careful not to entangle or pinch the power cord and
Terminal Block
(appearance may vary)
Neutral
Terminal
Ground
Strap
Be sure Anti-Tip
Bracket is engaged
with the brace on
the range.
13