Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Power Cable; Disposal And Recycling - EINHELL BT-GG 200 P Mode D'emploi

Anleitung_BT_GG_200_P_SPK1:_
GB
You can now apply the glue by pressing the trigger.
Press both surfaces together immediately and apply
pressure. It takes about 30 seconds for the glue to
set.
If your gluing work is interrupted or completed,
always be sure to place the hot glue gun on the
support stand.
Important! Glue stains on textiles cannot be
removed.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8
15.09.2008 17:22 Uhr Seite 8
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Allow the equipment to cool down before you start to
clean it.
8.1 Cleaning
Keep all safety devices, air vents and the
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.