Ravelli RBH 150 V Manuel D'utilisation Et D'entretien page 90

Rev.2 14/01/2021
Pag.34
Setting ambient and boiler water temperature:
Set the two values following the indications given in the chapter "Description of the display"
Turning the device on
Keep the key ON/OFF pressed for a few seconds to turn on the stove.
The message "ADJUST THE RDS SYSTEM" indicates that the initial parameter testing and calibration procedure has
been completed unsuccessfully. This indication does not block the stove (see section WARNING POP-UP).
On the display of the handheld set appears the following:
Press and hold the ON/OFF button to turn off the stove and reset any alarms triggered. If the In case the infeed screw operations
described above have not been executed, the stove may fail to turn on.
Empty the brazier, reset the alarm and turn the stove on again. If the stove still fails to turn on, make sure the grate is perfectly fixed
to the support base; also check that there are no deposits that prevent the air to flow correctly and promote the ignition.
If the problem persists, contact the support service.
For models with automatic cleaning system, the active stove enables a cleaning cycle of the brazier upon ignition and before
IGNITION. In the event of FAILED IGNITION, it is not necessary to remove the unburnt pellet from the inside of the brazier
before turning on the stove again. As soon as the user restarts the stove, the operating system runs the operation without
enabling the cleaning device and without reactivating the pellet loading phase.
Sequence of ignition phases
SWITCH-ON- initial pellet loading
phase;
WAIT FLAME - flame development
wait phase;
FLAME PHASE - flame
stabilization and reduction of
combustion inside the brazier;
WORK - operating phase
described in the dedicated chapter;
Changing the power of the stove
MENU
USER
MANUFACTURER'S
TECHNICIAN
Press the key
"access menu" to
access the
MENU page
Use the UP/DOWN keys to change the operating
The power can be selected only when the stove is operating Upon every start-up, the stove operates with maximum power in order to
ensure greater heat input to the heating system.
All manuals and user guides at all-guides.com
Use and maintenance manual RBH 150 V - RBH 200 V
Press the key
"confirm"
to access the
USER page
power.
What happens if the batteries are empty?
If the battery is empty, inside the "drop"
will be displayed a symbol indicating
the "almost empty" state of the same,
maintaining the handheld unit functions
active.
As soon as the level of the battery
prevents the radio communication the
handheld set displays on full screen the
picture of empty battery and all device
functions are locked until the batteries
are replaced
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
Press the key
to access the
POWER SETTING page
By pressing the following key you will confirm the data
and go back to USER MENU
POWER SELECTION
"confirm"