Publicité
Les langues disponibles
Les langues disponibles
SM 1619X04037 01-10:SM 1619X04037 01-10 1/12/10 3:00 PM Page 9
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum
nameplate RPM by the pressure you apply to
the trigger. Apply more pressure to increase
the speed and release pressure to decrease
speed. This accurate speed control enables
you to drill without center punching. It also
permits you to use as a power screwdriver.
Bits are available for driving screws as well as
running bolts and nuts.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
W RNING
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 1). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
FORWARD/REVERSE INDICATOR LIGHTS
(Model 2412 only)
Your tool is equipped with lights which
indicate the rotation of the bit.
For forward rotation, (with bit pointed
away from you) move the lever to the far left
and a green indicator light depicting a forward
arrow will light up.
For reverse rotation move the lever to the
far right and the green indicator light depicting
a reverse arrow will light up.
To stop in either direction just release the trigger.
To activate trigger lock move lever to the center
off position (Fig. 1).
FUEL GAUGE
(Model 2412 only)
Your tool is equipped with a fuel gauge that
alerts you when the battery capacity is getting
low. When the battery capacity reaches 30%
or less a red LED illuminates indicating the
battery will require charging (Fig. 2).
All manuals and user guides at all-guides.com
Operating Instructions
FIG. 2
FUEL
G UGE
LED
-9-
ADJUSTABLE CLUTCH
Your tool features 16 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 15. The drill "
will lock up the clutch to permit drilling and
driving heavyduty work, and also enables bits
to be changed quickly and easily in the
keyless chuck (Fig. 1).
BRAKE
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
GEAR SHIFTING (Model 2414 only)
Your tool is equipped with two separate gear
ranges, Hi-torque and High-speed. Hi-torque
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High-speed provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the Hi-torque or High-speed position
(Fig. 1).
BATTERy CHARGE CONDITION
INDICATOR LIGHTS
(Model 2414 only)
Your tool is equipped with charge condition
indicator lights (Fig. 3). The indicator lights
shows the charge condition of the battery
during operation.
The charge condition can be checked for a
few seconds when the trigger is depressed
fully or halfway.
LED
Continuous lighting 3 x blue
Continuous lighting 2 x blue
Continuous lighting 1 x blue
Slow flashing
The 3 LED's of the battery charge condition
indicator will flash rapidly when the battery
temperature is not within the operating
temperature range of -20˚C to +60 ˚C.
" position
Capacity
66% - 100%
34 - 66%
11 - 33%
0% - 11%
FIG. 3
B TTERY CH RGE
CONDITION
INDIC TOR LIGHTS
Publicité
