Publicité
Les langues disponibles
Les langues disponibles
MOUNTING PLATE
1.
Separate 4 Toggle Bolts
INSTALLATION HARDWARE, from the Toggle Nuts.
2.
Match 5/8" holes (not in studs), drilled through
WALL TEMPLATE into wall to corresponding holes
on Mounting Plate.
3.
Insert Toggle Bolts into matched openings on
Mounting Plate. Put Toggle Nuts on Toggle Bolts.
See Figure 17.
Figure 17
Mounting Plate
4.
Position the Mounting Plate with the Toggle Bolts
attached at the wall location and insert Toggle Nuts
and Bolts through the holes in the wall with the
Toggle Nuts closed. Figure 18. Use Wood Screws
to attach the Mounting Plate to studs.
1
NOTE: Before insertion, be sure you leave a space
more than the thickness of the wall between the
Mounting Plate and the end of each of the Toggle
Nuts (in the closed position). If you do not leave
enough space, the Toggle Nut will not be able to
open on the other side of the wall. Also, once a
Toggle Nut opens, it cannot be withdrawn from
the hole; therefore make sure all of the Toggles
are in the correct position before insertion.
5.
Align the Mounting Plate carefully and hold in position
while tightening Toggle Bolts. Pull Toggle Bolt toward
you and turn clockwise to tighten. Figure 19.
Figure 18
Space more
than wall
thickness
Wall
8
All manuals and user guides at all-guides.com
Models MWOR530A2ASS, MWOR530A3ASS
, packed in the
2
Toggle Bolt
Figure 19
10. PREPARATION AND USE OF
THE CARTON TO ASSIST IN
THE INSTALLATION OF THE
MICROWAVE OVEN
Utilization of the carton may make installation easier.
1. Place carton upside down. See Figure 20.
Figure 20
Top Side
2. Using cutting line around the carton, cut into two
pieces (A) and (B). See Figure 21.
Figure 21
3. Position oven to assist in mounting to the wall. See
Figure 22.
Figure 22
Installation Manual
ENGLISH
Cutting Line
(A)
(B)
Publicité
