FULGOR MWOR530A2ASS Manuel D'installation page 4

1. MOUNTING SPACE
This Microwave Oven requires a mounting space on
a wall as shown in Figure 1. It is designed to be used
under standard 12" wall cabinets.
Figure 1
12"
30"
15.5"
2. WALL CONSTRUCTION
This Microwave Oven should be mounted against
and supported by a flat vertical wall. The wall must
be flat for proper installation. If the wall is not flat, use
spacers to fill in the gaps. Wall construction should
be a minimum of 2" x 4" wood studding and 3/8" or
more thick dry wall or plaster/lath. The mounting
surfaces must be capable of supporting weight of 110
pounds—the oven and contents—AND the weight of all
items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one
2" x 4" wall stud.
To find the location of the studs, one of the following
methods may be used:
A. Use a stud finder, a magnetic device which locates
the nails in the stud.
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate stud
location.
The center of the stud can be located by probing the
wall with a small nail to find the edges of the stud and
then placing a mark halfway between the edges. The
center of any adjacent studs will normally be 16" or 24"
to either side of this mark.
4
All manuals and user guides at all-guides.com
Models MWOR530A2ASS, MWOR530A3ASS
30" or more from
cooking surface
Backsplash
66" or more
from floor
3. ELECTRICAL GROUNDING
INSTRUCTIONS
This appliance must be grounded. This oven is
equipped with a cord having a grounding wire with
a grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded in
accordance with the National Electrical Code and local
codes and ordinances. In the event of an electrical
short circuit, grounding reduces risk of electric shock by
providing an escape wire for the electric current.
WARNING - Improper use of the grounding plug
can result in a risk of electric shock.
ELECTRICAL REqUIREMENTS
The oven is equipped with a 3-prong grounding plug.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR
REMOVE THE GROUNDING PIN FROM THE PLUG.
DO NOT USE AN EXTENSION CORD.
The Power Supply Cord and
plug must be connected to a
separate 120 Volt AC, 60 Hz,
15 Amp, or more branch circuit,
single grounded receptacle. The
receptacle should be located
inside the cabinet directly above
the Microwave Oven mounting
location as shown in Figure 2.
Figure 2
Ground
Receptacle
*Opening for
Power Cord
IMPORTANT: * Power cord opening for metal
cabinets: Deburr opening to remove rough edges.
NOTE:
1. If you have any questions about the grounding or
electrical instructions, consult a qualified electrician
or serviceperson.
2. Neither Fulgor nor the dealer can accept any liability
for damage to the oven or personal injury resulting
from failure to observe the correct electrical
connection procedures.
Installation Manual
ENGLISH
3-Prong Plug
Grounding Pin
3-Prong Receptacle
Ground Receptacle Box