Publicité
Les langues disponibles
Les langues disponibles
7. PREPARATION OF THE OVEN
1.
Turn oven on the side. See Figure 5.
2.
Follow steps (A)-(D) to remove mounting plate
from the back of the oven as shown in Figure 5.
(A) Release mounting plate by pulling out the
lever that is on the bottom of the oven. See
Figure 6.
(B) When lever is out, pull that side of the mount-
ing plate away from the oven. See Figure 5.
(C) Repeat step (A) on other side.
(D) Repeat step (B) on other side.
Figure 5
(A)
(C)
Figure 6
(A)
Use
screwdriver
to assist in
releasing
mounting plate.
Bottom of
Microwave
8. VENTILATION SYSTEM
(PREPARING OVEN FOR INSTALLATION)
This Microwave Oven is designed for adaptation to
three types of hood ventilation systems. Select the type
required for your installation.
RECIRCULATING — non-vented, ductless.
Follow installation procedure (A). Recirculating requires
the use of the Charcoal Filter, which has already been
installed in the oven.
6
All manuals and user guides at all-guides.com
Models MWOR530A2ASS, MWOR530A3ASS
(B)
(D)
Mounting
Plate
HORIzONTAL EXHAUST — outside ventilation.
Follow installation procedure (B).
VERTICAL EXHAUST — outside ventilation.
Follow installation procedure (C).
(A) RECIRCULATING:
NON-VENTED, DUCTLESS OPERATION
1.
The unit is shipped assembled for recirculating. The
Exhaust Damper Assembly 8 is not required for
recirculating operation.
2.
The Charcoal Filter should be replaced every 6 to
12 months, depending on use.
(B) HORIzONTAL EXHAUST:
1.
Remove 2 screws from back edge and 3 screws
from the top center of Fan Cover Bracket. Save
2 screws to be used later and discard remaining
3. Remove Fan Cover Bracket by sliding it in the
opposite direction of the arrow on the Fan Cover
Bracket, as shown in Figure 7.
2.
Lift Hood Fan Unit carefully and slip wires out of
cavity. See Figure 8.
CAUTION: Do not pull or stretch hood fan
wiring.
Figure 7
3.
Rotate the Hood Fan Unit 180˚ so that the fan
blade openings are facing the back of the oven.
See Figure 9 (A). Replace Hood Fan Unit into the
oven. Be careful not to pinch the wire and the Hood
Fan Unit. See Figure 9 (B).
4.
Put the wire back into the cavity. See Figure 10.
Figure 9
(A)
Rotate 180˚
(B)
Installation Manual
ENGLISH
OUTSIDE VENTILATION
Figure 8
Figure 10
Save fan cover
bracket for future
instructions.
Publicité
