Royal Sovereign RWD-500W Guide De L'utilisateur page 9

OPERATING PROGRAMS
There are two types of preset programs (Energy Saving Mode and Normal Mode) which allow the water cooler to be used in
different ways. To switch between two modes you simply have to press the program button.
Energy Saving Mode:
The Energy Saving feature helps save energy, by lowering the temperature of the heated water. This feature may be ideal when
not in heavy use such as if the water dispenser is not used at night time or on weekends.
To utilize the Energy Saving feature, push the PROGRAM button down (in). A (green) E-S indicator light will be displayed. During
Energy Saving operation the red "WARM" cycle indicator will be displayed until the temperature of the water in the reservoir
reaches 60˚C/140˚F. Once the temperature reaches 60˚C/140˚F (approximately 4 minutes) the red "WARM" indicator will turn
off and will remain off until the temperature of the water in the reservoir drops to 50˚C/122˚F at which time the red "WARM"
cycle indicator will turn on and the cycle will start again.
If the unit is set to Energy Saving mode and you want to heat the water, simply press the "HOT WATER" button. A (red) "HOT"
cycle indicator will be on and water temperature in the reservoir will be heated to 90˚C/194˚F, within about 4 minutes. Once the
water temperature reaches 90˚C/194˚F, the (red) "HOT" cycle indicator will turn off and will remain off until the "HOT WATER"
button in pressed again.
Normal Mode:
Normal Mode is the standard setting. In Normal mode, an orange NORM indicator light will be displayed. In Norm Mode operation,
the (red) "HOT" cycle indicator light will be on until the temperature of the water in the reservoir reaches 90˚C/194˚F
(approximately 9 minutes). The (red) "HOT" cycle indicator will turn off and will remain off until the temperature of the water in
the reservoir drops to 81˚C/178˚F at which time the (red) "HOT" cycle indicator will turn on and the cycle will start again.
** During "NORMAL" mode, the "HOT WATER" button is non-functional.
Cold Temp (Energy Saver / Normal Modes):
The cold water cycle is not affected by either program and continuously runs to maintain a cold water temperature between
7˚C/44˚F and 10˚C/50˚F. Once the "Cold Switch" at the rear of the unit is turned ON, a blue "COLD" cycle indicator will be on
until the temperature of the water in the reservoir drops to 7˚C/44˚F or less. The blue "COLD" cycle indicator will turn off and the
cooling cycle will stop until the temperature reaches 10˚C/50˚F, at which time the blue "COLD" cycle indicator will turn on again
and the cooling cycle will start again.
All manuals and user guides at all-guides.com
9
RWD-500W