Télécharger Imprimer la page

Royal Sovereign RWD-500W Guide De L'utilisateur page 6

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION GUIDELINES
• Safely open the box and remove the exterior and interior packing
• Place your appliance on a floor that is strong enough to support the dispenser when it is fully loaded (Up to 36kg/80lbs including 18
kg/40lb water bottle). The unit is provided with four plastic feet, if it does not sit level on the floor; adjust the front feet to level the unit
well to the floor
• Place the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.) Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to
perform correctly
• Allow at least 2 inches of space between the water dispenser and the wall to allow proper air circulation as well as to cool the
compressor
• Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or remove the third (ground) prong from the
power cord under any circumstances
• This water dispenser is not recommended for outdoor use
• Do not locate the dispenser in area where the temperature may fall below 0˚C/32˚F.
• Keep the area around the dispenser dust and dirt free
• Keep the reserve supply of water bottles away from excessive heat and light
• Only unplug the water cooler for maintenance
Initial Setup
Although the water dispenser is pre-cleaned at the factory the reservoir it is recommended that the unit be flushed with fresh water before
use. Please follow the steps below for the initial setup:
• Keep the unit unplugged
• Fill the water tank with tap water to capacity. Wait for 5 minutes until water settles.
• Slide child safety button then push the hot water faucet until water comes out, then stop.
• Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to do that we must wait for the hot water
to reach temperature in approximately 10 minutes, and then wait for the cold to reach temperature (another 40 minutes, approximately)
• Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at a time until no more water remains
• (Note: To facilitate this operation, use a large container)
All manuals and user guides at all-guides.com
6

Publicité

loading