Royal Sovereign RWD-500W Guide De L'utilisateur page 11

TROUBLESHOOTING
Problem
Water dispenser does not operate.
Water cooler is not cold enough.
Water dispenser hot water is not hot enough.
Compressor turns on and off frequently.
Vibrations.
The water dispenser seems to make too much noise.
Bottle feels warm.
Water bottle is hot.
Additional Problems
If you were unable to fix your problem after consulting the troubleshooting section then you should call a technician to resolve the issue
WIRING DIAGRAM
Included is the Wiring Diagram of the WATER DISPENSER
All manuals and user guides at all-guides.com
Unit not plugged in.
The circuit breaker tripped or a blown fuse.
Check to be sure the cold switch on the back is ON.
The water dispenser does not have the correct clearances.
Check to be sure the hot switch on the back is ON.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct clearances.
Check to assure that the water dispenser is level.
The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your water dispenser.
Contraction and expansion of the inside walls may cause popping and crackling noises. The
water dispenser is not level.
The water system is overfilled. Dispense Cold water until air is released into the bottle.
Water is boiling in the hot tank and bubbling up into the bottle. Press the hot dispenser button
until water flows to remove air from the hot tank.
11
Possible Cause
L
E
N
RWD-500W