Hisense HS212F Manuel De L'utilisateur page 13

All manuals and user guides at all-guides.com
USB Operation
1 Insert the USB device.
2 Press the button repeatedly on the unit
or on the remote control to select USB mode.
3 During playback:
- To pause or resume play, press the
button on the remote control.
- To skip to the previous/next
/
buttons on the remote control.
Tips:
• The unit can support USB devices with up to
32 GB of memory.
• This unit can play MP3/WAV/WMA.
• The unit support FAT32.
• Embedded USB full speed host for USB
applications should not exceed 6.5Mbps.
•
can not exceed 4608 byte, otherwise it would
lead to staccato sound or no sound.
Troubleshooting
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
• Ensure that the AC cord of the unit is
properly connected .
• Ensure that there is power at the AC outlet.
• Press STANDBY button to turn the unit on.
Remote control does not work
• Before you press any playback control button,
• Reduce the distance between the remote
control and the unit.
• Insert the battery with its polarities (+/-)
aligned as indicated.
• Replace the battery.
• Aim the remote control directly at the sensor
on the front of the unit.
No sound
Increase the volume. Press VOL + on the
-
remote control or on the soundbar.
- Press
the soundbar is not muted.
-
source.
- When using either of the Digital inputs, if there
is no audio:
- Try setting the TV output to PCM or
- Connect directly to your Blu-ray/other source,
some TVs do not pass through digital audio.
- Your TV may be set to variable audio output.
e, press the
FIXED or STANDARD, not VARIABLE. Consult
your T V's user manual for more detailed
information.
- If using Bluetooth, ensure that the volume on
your source device is turned up and that the
device is not muted.
I can't nd the Bluetooth name of
this unit on my Bluetooth device for
Bluetooth pairing
• Ensure the Bluetooth function is activated on
your Bluetooth device.
• Ensure you have paired the unit with your
Bluetooth device.
This is a 15 mins power
one of the ERPII standard requirement
for saving power
• When the unit's external input signal level is too
15 minutes. Please increase the volume level of
your external device.
The subwoofer is idle or the indicator
of subwoofer do not light up.
• Please unplug power cord from the mains
sockect, and plug it in again after 4 minutes to
resent the subwoofer.
13
(MUTE) on the remote control to ensure
EN
function,