Publicité
Les langues disponibles
Les langues disponibles
Restore initialization
If the user accidentally sets the display language of the wire controller to a language that the user does
not know, the following three steps can be used to restore the wire controller to the factory setting and
reset the display language:
1)Power off the wireline controller and power it on again. Press and hold
+
+
to enter the
following page within 60 seconds.
2)Press the buttons from left to right, from top to bottom, click
->▲ ->
->... Turn on 1, 2, 3, 4, 5,
6, 7, 8 and 9, wait for 100% initialization, and enter the FCT page. After entering the FCT page, the
version number is displayed. All set parameters of the equipment are reset to the default parameters, and
saved. The timing settings and fault records are cleared. The equipment returns to the factory state. (exit
FCT after power on again).
3)Power off the wireline controller and power it on again. The display language will be reset. Press
" "" "" " " " to select the language of the remote controller. After the language setting is completed,
click "
", select "YES", and then click "
" to enter the SETTING ADDRESS interface. After setting
SETTING ADDRESS, click"
" to enter GENERAL SETTING. Then after setting GENERAL SETTING,
click "
".
V.1
Publicité
