Publicité
Les langues disponibles
Les langues disponibles
Preventive measures
The spray extraction method may only be used if the textile layer and backing cannot be damaged.
Be careful with wood or water-sensitive floors.
•
Be careful with carpets that have been laid with water-soluble adhesive.
•
Be careful with carpets with water-sensitive backing fabric (such as jute).
•
•
Be careful with carpets made of natural fibers.
Observe the carpet manufacturer's instructions.
•
•
If you are in doubt about the color fastness, rub in a small amount of detergent on a
hidden part of the carpet using a white cloth. If the cloth discolors, the carpet is not "color-
fast".
Preparing the carpet
Vacuum the carpet thoroughly before spray extraction.
•
Pre-treat stains and badly soiled areas with special cleaning products or stain removers.
•
Use in case of normal dirt
•
Switch on both switches on the appliance for the suction device and pump (fig. 2c).
Apply the spray nozzle to the edge of the carpet and press the dosing valve.
•
•
Pull the nozzle backwards over the carpet while applying a constant gentle pressure on the
hand tube (covering 1 m in 5 seconds).
•
Close the dosing valve just before reaching the end of a track and suck up the sprayed
water.
The next track should overlap the previous one by 2 cm.
•
Drying time can be reduced if the carpet is vacuumed again with the extraction device.
•
Use in case of heavy contamination
Pre-spray with cleaning fluid with the dosing valve open and the suction motor
•
switched off.
Allow the detergent to sink in but never let it dry.
•
Cleaning as described in "Use in case of normal dirt".
•
Repeat the cleaning procedure, where possible in the transverse direction.
•
Only perform the second cleaning operation on a completely dry carpet.
Monitoring the operation
If the suction power starts to drop, empty the waste water tank.
•
Before refilling the fresh water tank (fig. 5) always first empty the waste water tank.
•
After use
Switch off the appliance.
•
Pull out the mains plug.
•
Check the filter in the fresh water tank, cleaning it if necessary (fig. 5b).
•
Empty and clean the waste water tank.
•
Storage
•
Roll up the connecting cable.
Protect the appliance and auxiliary equipment from frost.
•
All manuals and user guides at all-guides.com
Publicité
