Publicité
Les langues disponibles
Les langues disponibles
possible damage to the water dispenser and or its surroundings.
·
Place the 5-gallon bottle of water on the water intake, allow water to stand for
approximately one minute.
·
Open water faucets to insure water flows from both faucets.
·
Check the area around the drain valve at the rear of the unit for leakage.
·
Plug dispenser into the electrical outlet.
·
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined, except turn the switch marked HOT "OFF" to
avoid leaving residues in hot water tank.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we
recommend that you turn the HOT switch to the "OFF" position.
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
Ø Steps to replace water bottles
·
Use a clean cloth to wipe off neck of bottle.
·
Remove cap.
·
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
·
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
·
Wipe off any water which may have splashed on dispenser top.
·
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full
cups of water to insure the water flows properly and the water reservoir is at the proper level.
~
~
WARNING
7
Publicité
