Avanti WDHC770I0W Manuel D'instructions page 10

You can solve many common water dispenser problems easily, saving you the cost
of a possible service call. Try the suggestions outlined below to see if you can solve
the problem before calling the service.
PROBLEM
Water dispenser does not operate.
Water cooler is not cold enough.
Water dispenser hot water is not hot enough.
Compressor turns on and off frequently.
Vibrations.
The water dispenser seems to make too much
noise.
Bottle feels warm.
Water bottle is hot.
DO NOT TURN ON THE HOT WATER POWER SWITCH BEFORE FILING THE HOT
WATER TANK WITH WATER. THIS WILL CAUSE THE UNIT TO OVERHEAT AND
SHUTDOWN.
Install the water bottle and allow the tanks to fill with water for approximately 10 – 15
minutes. Before turning on the HOT water power switch.
Your unit is equipped with an AUTOMATIC SAFETY SHUTOFF SWITCH which will turn
the unit off until the hot water tank cools to a safe temperature.
Usual time to reset is approximately 30 – 45 minutes, once the temperature reaches a
safe level, the unit will reset and begin to operate normally.
If the unit has gone into RESET MODE, turn off the hot water power switch ensure there
is water in the tanks and allow the unit to cool down.
PROBLEMS WITH YOUR WATER DISPENSER
TROUBLESHOOTING GUIDE
ATTENTION / WARNING
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
Check to be sure the cold switch on the back is ON.
The water dispenser does not have the correct
clearances.
Check to be sure the hot switch on the back is ON.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct
clearances.
Check to assure that the water dispenser is level.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your water
dispenser.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The water dispenser is not level.
The water system is overfilled. Dispense Cold water
until air is released into the bottle.
Water is boiling in the hot tank and bubbling up into the
bottle. Press the hot dispenser button until water flows
to remove air from the hot tank.
10