Publicité
Les langues disponibles
Les langues disponibles
DO NOT TURN ON THE HOT WATER POWER SWITCH BEFORE FILING
THE HOT WATER TANK WITH WATER. THIS WILL CAUSE THE UNIT TO
OVERHEAT AND SHUTDOWN.
Install the water bottle and allow the tanks to fill with water for approximately 10
– 15 minutes. Before turning on the HOT water power switch.
Your unit is equipped with an AUTOMATIC SAFETY SHUTOFF SWITCH which
will turn the unit off until the hot water tank cools to a safe temperature.
Usual time to reset is approximately 30 – 45 minutes, once the temperature
reaches a safe level, the unit will reset and begin to operate normally.
If the unit has gone into RESET MODE, turn off the hot water power switch
ensure there is water in the tanks and allow the unit to cool down.
Before Using Your Water Dispenser
·
Check to be sure the following parts are included:
§
Instruction manual
§
2 extra drain plug seals
§
4 Height Adjustment Feet
§
1 Bottle Inlet Adjustment Ring
·
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
·
The water dispenser is pre-cleaned at the factory but the reservoir and water lines
must be flushed with fresh water before use as follows:
·
Keep the unit unplugged.
·
Fill water tank with tap water full to capacity (more than 3/4 of a gallon). Wait for 5
minutes until water settles.
·
Press the hot water faucet until water comes out, then stop.
·
Plug the dispenser into the electrical outlet. Both heating and cooling indicator lights
on front will light up at first. We are ready to complete the first cycle. In order to do
that, wait for the hot water indicator light to go off first (approximately 10 minutes),
then wait for the coldwater indicator light to go off (another 40 minutes,
approximately).
·
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the
faucets one at a time until no more water remains.
(Note: To facilitate this operation, use a large container).
·
Then, drain any water left in the tanks by opening the drain plug located on the back,
until it drains completely.
·
Proceed to close the drain cap.
Be sure the drain plug seal is in place. If not, replace with one of the spares
included with this manual.
Closing the drain cap without the seal in place will result in leakage and
ATTENTION / WARNING
OPERATION INSTRUCTIONS
6
Publicité
