Télécharger Imprimer la page

Lorex LW2201 Serie Manuel D'instruction page 11

Publicité

Les langues disponibles

Les langues disponibles

Setting up the Wireless Receiver
To set up the wireless receiver:
1. Screw on the antenna to the back of the receiver.
2. Connect the Yellow video cable and White audio cable (mono) to your TV, DVR, or
observation system. Use the RCA/BNC Adapter (included) to connect the video cable to a
BNC port.
3. Connect the Black power cable from the receiver to the cable of the Power Adapter; plug the
Power Adapter to an outlet or surge protector.
4. Place the receiver in a place that will have a clear reception to your camera*.
Note: Use the included double-sided tape to secure the receiver to a flat surface.
ATTENTION: Make sure to first connect and power on the cameras before powering
on the monitor; this will ensure a proper connection.
Connecting the Camera
Before you install the camera, carefully plan where and how it will be positioned, and where you will route
the cable that connects the camera to the power adapter.
Before starting permanent installation, verify its performance by observing the image on a monitor
when camera is positioned in the same location/position where it will be permanently installed.
Installation Warnings:
Aim the Cameras to best optimize the viewing area: Select a location for the camera that provides
a clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to
a strong light source or direct sunlight.
Avoid installing the cameras where there are thick walls or obstructions between the Cameras
and the Receiver*.
Select a location for the camera that has an ambient temperature between 14°F~113°F
(-10°C~45°C)
*Avoid installing in a location which requires the wireless signal to pass through cement, concrete, and
metal structures. This will reduce the range of transmission.
All manuals and user guides at all-guides.com
Setting up the Wireless Receiver
11

Publicité

loading