Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Original-Bedienungsanleitung FUXTEC FX-AF1196_de_en_fr_ita_rev02
Belts squeal when idling and in
reverse.
Belts squeal in forwarding
operation.
Excessive heat builds up in the
gearbox/chipper
blade
during milling.
64
Adjust the front belt guide:
•
Stop the engine and allow the
–
muffler to cool.
Disconnect the spark plug wire and pull
–
it off the spark plug
Remove the belt guard
–
Pull down the drive safety control levers.
–
Manually bend the belt guide forward,
–
leaving 1/16 inch or less of slack between
the belt guide and the belt
Replace the belt guard and spark plug wire
–
Adjust the tabs on the rear belt guide.
•
Stop the engine and allow the
–
muffler to cool.
Disconnect the spark plug wire and pull
–
it off the spark plug
Move the drive safety levers to the idle
–
position
Remove the belt guard
–
Adjust the belt return tabs
–
With the drive safety control levers released,
•
bend the metal tabs on the reverse belt
guide to 1/64 or less from the reverse belt.
Replace the belt guard and spark plug wire
•
Remove
accumulated
•
following
the
area
instructions of the chipper blade shaft.
Observe all safety instructions.
Check the gearbox oil and top up if necessary.
•
plant
debris
General
Care
section's
by
Publicité
