Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Original-Bedienungsanleitung FUXTEC FX-AF1196_de_en_fr_ita_rev02
7.1 STARTING
7.1.1 Cold start
•
Open the fuel lever.
•
Move the throttle lever to the start position.
•
Turn the switch to ON.
•
Move the throttle lever to the middle position.
•
When the engine starts, gradually set the throttle to "no choke."
7.1.2 Warm start of the engine
Restarting an already warm engine from a previous operation does not
usually require the choke's use.
•
Turn the switch to ON.
•
Pull the starter rope out quickly until the engine starts.
•
Set the throttle to "high" to get the best milling performance.
7.2 Idle speed
Using the "low" position on the throttle lever, you can reduce the engine
load when you are not currently milling. Lowering the engine speed to "idle"
will extend the engine's life. Follow the same procedure to save fuel and
reduce the device's noise level.
7.3 Shutting down
To stop the engine at any time, move the engine ON / OFF switch to the
OFF position.
To stop the wheels and chipper blades at any time, move the clutch levers
to the neutral position.
7.4 Milling
•
Set the depth control lever to the desired machining depth.
NOTE: Raise the depth control lever one hole at a time. Test the
functionality of the petrol rotary cultivator after each hole. Raising the
56
Publicité
