Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Original-Bedienungsanleitung FUXTEC FX-AF1196_de_en_fr_ita_rev02
Problem
The engine does not start
Engine runs erratically or stops
during operation.
The engine is difficult to start.
Lack of or insufficient engine
power.
The engine does not stop when
the throttle is in the stop
position.
Tiller moves forward when
started.
Tiller is challenging to control
when milling (device jumps or
stalls forward).
Hoeing knives turn, but wheels
do not turn.
Chopping knives and wheels
turn, but the tiller does not
move.
63
Solution/ Troubleshooting
Add gasoline to the fuel tank.
•
Connect the spark plug wire to the spark
•
plug.
The throttle must be in a choke position for a
•
cold start.
Clean or replace the air cleaner.
•
Drain old fuel and replace it with fresh. Use
•
a fuel stabilizer at the end of the season.
Make sure the spark plug wire is firmly
•
connected to the spark plug.
To start the engine, the driving safety levers
•
must be moved to the
idle position.
Raise the shallow tillage chopping blades by
•
lowering the depth control lever.
Remove and clean the fuel tank.
•
Clean or replace the air cleaner.
•
Improper carburettor adjustment -
•
contact an authorized engine repair
shop.
Replace the spark plug and adjust the gap.
•
Drain and refill the fuel tank and
•
carburettor.
Refer to the engine operator's manual
•
to check and adjust the throttle.
To start the engine, move the travel
•
safety levers to the idle position.
Lock the wheels in the milling position.
•
Raise the hoeing blades for shallower
•
tillage by lowering the depth control
lever.
Lock the wheels in the milling position.
•
Internal transmission failure contact your
•
dealer.
Lower the chopping blades for a deeper
•
tillage depth by raising the depth control
lever.
Publicité
