Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE SPRAYER
• To Prime Pump
• Turn switch to on position.
• Remove tank cap.
• Spray liquid back into tank to prime pump.
• Release shut-off handle. Pump should stop running.
• Replace cap & begin spraying.
• When finished spraying turn switch to off position.
• Re-charge sprayer.
Note: Unit is equipped with a battery protection circuit. If sprayer abruptly stops after spraying for
an extended period of time, the battery may require charging.
POWDER-BASED CHEMICALS
Powder-based chemicals (powder mixed with liquids to make the spraying agent) are usually
abrasive and can cause wear. When you use a powder-based chemical in your sprayer, make sure
it is thoroughly dissolved in the liquid solution. Thoroughly clean and flush the sprayer with water to
extend the life of the sprayers parts.
CLEANING
•
Always empty the sprayer and clean the tank thoroughly after each use.
Other Cleaning Hints:
• Improper spray distribution usually means the nozzle is clogged, remove the nozzle and clean it.
• Soap can be added to the water to clean the tank.
• Do not use strong cleaning agents or abrasives.
• If you use a chemical agent to clean the tank follow the manufacturer's recommendations for the
disposal of the waste water.
• Follow the chemical manufacturers instructions for clean up.
STORING / MAINTAINING YOUR SPRAYER
• The sprayer should be stored out of direct sunlight in a cool dry space.
• Before freezing weather make sure to drain all liquid in the tank, pump, hose,
shut-off valve, wand and nozzle, to avoid liquid expansion and cracking in the sprayer components
(See "Cleaning" section). Lock the shut-off valve in the "open" position.
• When service is required call your nearest dealer and always insist on original manufactured
replacement parts.
• Inspect the hose, wand, tank and shut-off valve for wear, damage or leaks on a regular basis
and repair defects promptly.
Chapin Sprayer Operator's Manual - English
6E
Publicité
