Publicité
Les langues disponibles
Les langues disponibles
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining
Nut
2 STAGE FILTERING SYSTEM
This backpack sprayer is equipped with a 2 stage filtering
system (Figure 1-2). Stage 1 is a filter basket incorporated into
the tank opening where fluid is added. Stage 2 is a removable
filter incorporated into the shut-off assembly. Periodic
cleaning of these filters is recommended to ensure consistent
fluid flow through the sprayer. This will also reduce sprayer
component wear.
The stage 2 filter is a removable filter incorporated into the
inlet side of the shut-off valve (see section "Disassembling
and Repairing the Shut-off Valve") . Make sure pressure is
released before detaching the hose from the shut-off.
FILLING THE SPRAYER
Make sure the filter basket is in place to keep debris from entering the tank.
Determine the amount of mixture needed for your application. Add the proper amount of water to the
tank. Add the proper amount of liquid chemical to the tank (check the chemical label for proper ratio of
chemical). Stir mixture in tank with a clean utensil (like a paint stirrer). The tank will hold the 2-gallon
(7.6L) capacity plus up to 64 ounces of the chemical.
It is not necessary to completely fill the sprayer tank with each use. You can fill the tank with only the
amount needed for each application.
Always follow the manufacturer's instructions included on their product label.
Wand
O-ring
Chapin Sprayer Operator's Manual - English
Shut-off
Valve
Figure 1
Figure 2
5E
Stage 1
Filter basket
Stage 2
Removable Shut-off
Filter
Publicité
