IKEA BRANNPUNKT Manuel D'utilisation page 13

7. Check Operation
Refer to the User manual packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot
enough to cause burns.
1. Remove foam caps.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked
after cooktop and supply line connectors
have been carefully checked for leaks and the
cooktop has been connected to electric power.
To operate the surface burner:
A. Push in and turn a surface burner knob
to the LITE position. You will hear a small
ticking noise; this is the sound of the
electric ignitor which lights the burner.
B. After the burner lights, turn to the desired
flame size. The controls do not have to be
set at a particular mark. Use the marks as
a guide and adjust the flame as needed.
4. Adjust the "LOW" Setting of Surface Burner
Valves
Figure 10
A. Push in and turn each control to LITE until burner
ignites.
B. Push in and quickly turn knob to LOWEST
POSITION.
C. If burner goes out, Reset control to OFF.
D. Remove the surface burner control knob.
E. Insert a thin-bladed screwdriver into the hollow
valve stem and engage the slotted screw inside.
Flame size can be increased or decreased with the
turn of the screw.
All manuals and user guides at all-guides.com
Do not remove center screw.
NOTE: On models with twin burners (two rings of
flame), only the outer burner is adjustable.
Adjust flame until you can quickly turn knob from LITE
to LOWEST POSITION without extinguishing the flame.
Flame should be as small as possible without going
out.
Note: Air mixture adjustment is not required on
surface burners.
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air
to the cooktop is unobstructed.
Model and Serial Number
Location
The rating plate is located on the underside of the
cooktop.
When ordering parts for or making inquires about
your range, always be sure to include the model
and serial numbers and a lot number or letter
from the rating plate of your cooktop.
Your rating plate also tells you the rating of the
burners, the type of fuel and the pressure the
cooktop was adjusted for when it left the factory.
Before You Call for Service
Read the Before You Call for Service Checklist
and operating instructions in your User manual. It
may save you time and expense. The list includes
common occurrences that are not the result
of defective workmanship or materials in this
appliance.
Refer to the warranty in your User manual for our
service phone number and address. Please call or
write if you have inquiries about your product and/
or need to order parts.
WARNING
Burner Flame Size
Figure 11
Main
Top
13