Daewoo International DTD 7200 Manuel D'instructions page 30

 The handset on the charger does not charge

Make sure the batteries are inserted correctly.

Make sure the handset is placed properly on the base station/ charger

Batteries are defective. Purchase new ones for replace.
 No display

Make sure the batteries are charged

Make sure there is power and the phone is connected
 The handset no ring

Make sure the handset ring tone is turned on.
 Ring volume too low

Check if the ringing volume is set improper, reset it.
 Receive only

Check if P/T mode is properly set.

Check if you have set the barring number, if you want dial out this number, reset the barring number.
 The base can not page the handset

Repeat the registration operations to register the base and handset again.
 Most of the functions failed

Check if the batteries are strong enough, charge the batteries.

If batteries are OK, remove the battery, unplug the lines and reinstall after 10 minutes.
Note: Due to continuous product development, all features and specifications are subject to change without
prior notice.
STATEMENT OF COMPLIANCE
Industrias Masats S.L.U hereby declares that the DTD-7200 product complies with the requisites and basic
safety requirements of EC RE TTE Directive 199/5/EC.
To check the entirely declaration of conformity of this model, visit www.electronicaflamagas.com.
All manuals and user guides at all-guides.com
30