Allmatic KAIROS Serie Mode D'emploi page 7

1
DESCRIPTION
KAIROS family of clima! c sensors are made to manage awnings and pergolas.
The informa! on collected is transmi$ ed by radio, so it will not be necessary connec! ons between control
unit and sensor. These devices can work only with an Allma! c control unit compa! ble with the Kairos radio
informa! on. There are various types of clima! c sensor, powered from mains supply 100-240Vac or powered by
photovoltaic panel. For the working it will be necessary to learn the sensor on the control unit. Please refer to
the control unit instruc! on manual.
2
ASSEMBLING AND CONNECTIONS
Before the fi xing of the sensor on the wall it is possible to make the learning and any tests keeping the sensor
in the hand, in comfortable posi! on, nearby the control unit. With the mains supply versions use a provisional
surce of power. The se% ngs and data will be kept for all the ! me needed for the defi ni! ve fi xing.
The Allma! c clima! c sensors must be fi xed on the same wall of the awnings to protect up to a maximum 20/25
meters far from the control unit. The maximum distance could change signifi cantly in presence of metallic parts
or shielding between sensor and control unit.
Instruc! on for fi xing:
• Fix on the wall the plate 1 using the drilling plan
at pag.19 at least 2 meters from the earth
• Apply the seal 2 , by passing the cable through
the hole (only mains supply versions)
• Connect the cable to the terminals 3 of the
sensor (only mains supply versions)
• Screw with the screws 4 the sensor to the wall
plate, li# the sensor and screw the screws 5
• Remove the cap 6 and adjust the inclina! on of
the sensor so that the blades are in horizontal
posi! on (see fi xing examples), screw with an
allen wrench n°4 and relocate the cap 6 , from
below pushing up to the closing.
• Cover with the shells 7
120°
6-1622652 rev3
All manuals and user guides at all-guides.com
ITA ENG
04/02/2016
Fixing examples:
FRA ESP DEU POR
7/20