Télécharger Imprimer la page

Maverick MCS-29BL-80WP Manuel D'instructions page 5

Publicité

Les langues disponibles

Les langues disponibles

Charging the battery pack
Firstly you will need to charge the battery pack. Always use a charger that is rated for 2-3cell LiPo battery packs.
Charging time for an empty battery pack will vary depending on the capabilities of the charger purchased, but could
be as little as 30 minutes or up to 3 or 4 hours. Always follow the charger manufacturer's instructions in relation to
charging your battery pack.
Overcharging generates excessive heat and will damage the battery pack.
Use the charger with adult supervision and do not leave unattended. Do not use the charger near water or when
wet.
Do not use the charger if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fi re or
burns.
If you are unsure of the charge of the battery pack, use it in the vehicle until the vehicle slows, leave to cool and
then recharge.
Always remove the charger from the mains socket when not in use.
It is recommended that a LiPo-Safe charging bag is used when charging your LiPo Battery pack.
Caution
Installing the Transmitter Batteries
Installing the battery pack
All manuals and user guides at all-guides.com
*Charger and battery pack purchased separately
Do not use NiCd/NiMH battery chargers for LiPO batteries.
If you do not use a special charger for LiPO batteries, they will be
damaged.
Open the battery holding
tray to expose the empty
battery slots.
Insert 4 AA batteries
into the marked spaces.
Please note the correct
direction of the batteries
You need to insert the
battery pack in the open
section for the battery.
Use the chassis cut-out
for corner wiring if
needed. Use the straps
provided to secure the
battery in place.
5
Incorrect battery insertion
could damage the transmitter
2.4Ghz technology has done
away with the need for long
extendable aerials. The Aerial
on your transmitter is located
internally
Once fastened and secured
please connect the battery
plug into the speed controller
plug noting correct polarity.
Red to red, black to black.

Publicité

loading