Publicité
Les langues disponibles
Les langues disponibles
Changing the setup
The ESC has a number of programmable modes that can be altered to suite a variety of functions. Each set of green
LED fl ashes/beeps represents the programmable mode (1 fl ash = Running mode, 2 fl ashes = Drag brake force and
3 fl ahes = Auto-lipo settings etc..) and each set of red LED fl ashes/beeps represents that modes value. See the
table below for all the programmable modes and their values. When you enter the setup mode you need to keep the
button pressed until you enter the desired programme mode (green fl ashes/beeps). Once you reach that mode
release the button and that will allow you to change the mode value (red fl ashes/beeps). You need to switch off the
ESC to save the settings then re-do the process to change to a different mode or mode value setting. If you lose
your way with setup then you can return the unit to default settings by turning on the ESC, keeping the transmitter in
neutral and pressing the setup button for 3 seconds. Both red and green LED's will fl ash together 3 times to confi rm
this.
While switching on the ESC hold down the setup button. Continue to hold the
setup button while the red LED fl ashes.
Continue to hold the setup button until the green LED starts to fl ash.
Each green LED fl ash represents the programmable mode number.
Release the setup button when you reach the desired mode. You are now in the program mode setting.
Press the setup button to change the mode value. Each mode
value will have different amounts of red LED fl ashes.
Program Modes
Running
FWD w/Brake
Modes
Fwd/Rev/Brake
Rock Crawler
Drag Brake Force
Low Voltage Cut-Off
All manuals and user guides at all-guides.com
LED
1 red LED fl ash
LED
represents the
"No Protection" setting
This mode is for forward and brake only
This mode offers forward, brake and reverse. Note, The reverse uses a soft
start "Double Click" function which will only allow reverse to be activated once
the motor has stopped moving forwards.
This mode allows the reverse function to happen immediately. Drag Brake
should also be set to 100% to use this function for Rock Crawling.
This allows the setting of an automatic drag brake when the throttle stick is
returned to neutral, simulating the slight braking effect of a brushed motor while
coasting.
If the voltage of a LiPo battery pack is lower than the set threshold, the ESC
will cut off the output power by 50%. The ESC will completely cut off the output
power in 10 seconds.
10
LED
Red LED fl ashes for 4 seconds.
Green LED will begin to fl ash.
3 green LED fl ashes
represent the Low
LED
LED
LED
Voltage Cut-Off setting
for example.
In order to save the changes and settings
you must switch off the ESC. When you next
switch it back on it will have saved your new
settings. To make further alterations you
need to re-enter the mode values again.
LED
Publicité
