Publicité
Les langues disponibles
Les langues disponibles
From the remote control:
1. Press SOUND CONTROL.
The 10 keys are activated for sound adjustments.
2. Press SURROUND repeatedly
until the DAP mode — DANCE
CLUB, LIVE CLUB, HALL, or
PAVILION — appears on the
display.
The DAP indicator also lights up on the display.
3. Press REAR•L – / + to adjust the
rear speaker output level.
• Pressing REAR•L – decreases the output
level up to –10 dB.
• Pressing REAR•L + increases the output
level up to +10 dB.
Note:
You cannot adjust the left and right rear speaker output levels
separately.
4. Press EFFECT to select an effect
level you want.
• Each time you press the button, the effect
level changes as follows:
EFFECT 1
EFFECT 5
As the number increases, the selected DAP mode becomes
stronger.
Adjusting the Surround Modes — Dolby
Surround and JVC Theater Surround
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 11).
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• You can only adjust the effect level when selecting JVC Theater
Surround.
• You can only adjust the rear and/or center speaker output levels
when you have connected rear speakers and/or a center speaker
and have set "REAR SPK" and/or "CNTR SPK" correctly. See
page 11.
From the remote control:
1. Press SOUND CONTROL.
The 10 keys are activated for sound adjustments.
2. Press SURROUND repeatedly
until the mode — "PROLOGIC,"
"3 STEREO," or "THEATER" —
appears on the display.
• For "PROLOGIC" and "3 STEREO," the PRO LOGIC
indicator lights up on the display.
• For "THEATER," the PRO LOGIC and DAP indicators light
up on the display.
18
EN08-20.RX-5000V[C]/F
All manuals and user guides at all-guides.com
SOUND
CONTROL
SURROUND
3
– REAR•L +
5
8
EFFECT
4
EFFECT 2
EFFECT 3
EFFECT 4
SOUND
CONTROL
SURROUND
3
18
3. Press TEST to check the speaker
output balance.
"TEST " starts flashing on the display, and a
test tone comes out of the speakers in the
following order:
Left front speaker
Rear speaker
Note:
You can adjust the speaker output levels without outputting the
test tone.
9
4. Press CENTER – / + repeatedly to
adjust the center speaker output
level (from –10 to +10).
5. Press REAR•L – / + to adjust the
rear speaker output level (from
–10 to +10).
Notes:
• You cannot adjust the left and right rear speaker output levels
separately.
• You cannot use the REAR•R – / + buttons to adjust the rear
speaker level.
6. Press TEST again to stop the test
tone.
7. ONLY FOR JVC Theater
Surround:
Press EFFECT to select an effect
level you want.
• Each time you press the button, the effect
level changes as follows:
EFFECT 1
EFFECT 5
As the number increases, JVC Theater Surround becomes
stronger.
00.2.3, 8:27 PM
TEST
5
2
Center speaker
Right front speaker
– CENTER +
5
– REAR•L +
5
8
TEST
5
2
EFFECT
4
EFFECT 2
EFFECT 3
EFFECT 4
6
9
Publicité
