Joie litetrax pro Manuel D'instructions page 9

Use Rain Cover
see image
33
To assemble the rain cover, place it over the stroller, and then attach the 8 pairs of hook and loop fasteners on
the rain cover. 33
! Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
! When using the rain cover, please always check its ventilation.
! When not in use, please check that the rain cover has been cleaned and dried before folding.
! Do not fold the stroller after assembling the rain cover.
! Do not place your child into the stroller assembled with rain cover during hot weather.
Use Parent Tray
see images -
34 36
! Do not place any item that may do harm to the baby and stroller in the parent tray.
Use with Joie Child restraint
see images
-
37 43
When using with Joie child restraint Gemm, i-Gemm 3 & i-Level Recline & i-Snug 2 & i-Jemini, please refer to
the following instructions.
!
Before using the infant child restraint, please make sure the backrest has been adjusted to the lowest
position and the infant child restraint has been fastened.
!
If you have any problems about using the infant child restraint, please refer to their own instruction manuals.
!
Please don't fold stroller when attaching the child restraint.
Care and Maintenance
see image
44
! Removable seat pad may be washed in cold water and drip-dried. No bleach.
! To clean stroller frame, use only household soap and warm water. No bleach or detergent.
! From time to time, check your stroller for loose screws, worn parts,torn material or stitching. Replace or
repair the parts as needed.
! Excessive exposure to sun or heat could cause fading or warping of parts.
If stroller becomes wet, open canopy and allow to dry thoroughly before storing.
!
! If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get
the oil into the axle and wheel assembly.
44
! When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
15
NOTE
16