Publicité
Les langues disponibles
Les langues disponibles
V 2.0
FORWARD / REVERSE SWITCH
The forward / reverse switch (1) is conveniently mounted above the trigger switch
(See Figure 1). To make the drill rotate clockwise for drilling or driving screws, push the
forward / reverse switch to the left. To make the drill rotate counter clockwise for removing
screws, push the forward / reverse switch to the right.
NOTES:
•
Never change position of the forward / reverse switch while the chuck is turning.
•
The trigger switch will NOT function with the forward / reverse switch in the middle position.
VARIABLE SPEED TRIGGER SWITCH
This drill is equipped with a variable speed ON / OFF switch.
1. Turning the dial clockwise increases the speed of the hammer drill (2) (See Figure 2).
NOTE: Drill will turn at its slowest speed when the dial switch is turned counter clockwise.
2. To stop the drill, release the trigger switch.
NOTE: Drilling at a slow drilling speed for an extended period of time may cause
the drill motor to overheat. If the drill gets hot, stop drilling and allow it to cool
for at least 15 minutes.
TRIGGER SWITCH LOCK
The trigger switch lock-on feature allows the trigger switch to be locked in the ON position
at full speed when continuous operation for extended periods of time is required (See Figure 3).
To lock the trigger switch in the ON position, pull back on the trigger switch to start the drill
and push the trigger switch lock button (3) into the drill handle. Release the trigger switch
while holding the trigger switch lock button into the drill handle. The drill will continue to run.
To release the trigger switch lock button, pull the trigger switch back and then release the trigger.
DRILL / IMPACT SWITCH
The drill / impact switch (4) changes the drilling mode between conventional
drilling and impact for drilling concrete (See Figure 4). To operate the drill in drill mode,
push the drill / impact switch to the right. To operate the drill in impact mode,
push the drill / impact switch to the left.
WARNING! Always use carbide tipped masonry bits when drilling in masonry.
Any other type of bit could break and possibly cause serious injury.
INSTALLING THE AUXILIARY HANDLE
Install the auxiliary handle for two handed operation of the drill (See Figure 5).
This is particularly important for impact drilling in concrete.
1. Turn the auxiliary handle (1) counter clockwise to open the mounting collar (2).
2. Slide the auxiliary handle collar over the chuck and fully onto the drill housing (3).
3. Rotate the auxiliary handle to a comfortable position.
NOTE: The auxiliary handle must be horizontal when using the depth rod.
4. Turn the auxiliary handle clockwise to tighten the mounting collar onto the drill housing.
NOTE: Do not over tighten the auxiliary handle or you will break the mounting collar.
8
1/2 in. Hammer Drill
For technical questions call: 1-800-665-8685
8416331
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Publicité
