AEG DBS 5564 Mode D'emploi page 38

Купить в интернет-магазине http://clatronic-shop.com.ua
eNGLIsh
38
How can I replenish the water during operation?
Refill with water before the tank is completely empty.
The water level is too low if the pump is noisy during operation.
• Place the iron on the rest (6).
• Press the SETTING button to
select the POWER icon .
• Move the handle up until it
audibly locks into place.
• Remove the mains plug from the
socket.
• In order to remove the tank, press
the RELEASE button below the
water tank (Fig. F).
• Remove the lime filter cartridge
(Fig. G).
• Fill the tank up to the
maximum mark (Fig. H).
Do not overfill!
• Reinsert the lime filter
cartridge and
push the tank
back into the
base (Fig. I + J).
• You can now
continue ironing.
Fig. I
When you have finished
• Place the iron on the rest (6).
• Press the SETTING button to select the POWER icon
• Move the handle up until it audibly locks into place.
• Remove the mains plug from the socket.
• Empty the water tank if the ironing station is not in use for a
longer period of time.
• Allow the device to cool down before you put it away.
Cable Storage
Wind connecting tube and power cable around the cable holder
of the base. Fix connecting tube and power cable with the sup-
plied cable clip. Place the plug between the connecting tubes.
Lime Filter
Your steam iron station comes with a lime filter. The granules
of the lime filter cartridge are light brown to orange when new.
Depending on your water hardness the lime filter cartridge is
used up after approx. 25 full tanks. The lime filter cartridge must
be exchanged if the granules are completely black.
• Switch the device off.
• Remove the mains plug from the socket.
• Remove the water tank.
• Remove the lime filter cartridge.
• Fill the tank up to the maximum mark. Do not overfill!
• Replace the lime filter cartridge.
• Wait a few minutes before switching the device on again for
the lime filter cartridge to absorb water.
Паровая система AEG DBS 5564
Fig. F
Fig. G
Fig. H
Fig. J
.
Note:
Continue ironing with distilled water if you have no lime filter
cartridge at hand.
caution:
Leave the lime filter cartridge always attached!
cleaning
Warning:
► Always remove the mains lead before cleaning!
► Wait until the machine has cooled down completely!
► Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fire.
caution:
► Do not use a wire brush or any abrasive items.
► Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp cloth.
• Any residual water can remain in the water tank, but should
be poured out if it has been in the tank for a prolonged
period.
troubleshooting
Fault Possible Cause
Device does not Fault mains socket Try another socket.
work
The handle is not
moved down.
The electronic
temperature setting
is in position
The device Is the electric
suddenly stops circuit overloaded?
working during
operation
The blue indicator The temperature
on the display is is too high for the
flashing fast selected position.
Loud noises during The tank is empty. Check the tank.
steam operation
Remedy
Move the handle
down.
Select the desired
ironing tempera-
ture.
.
Check the house
fuse.
Wait until the iron
has cooled down
(the blue indicator
stops flashing).
Refill water.