Uberhaus HPS-C-GH Mode D'emploi page 6

Assembly
Step 1 – Attach Cast iron Assembly to Base
Take out all the parts of the Tabletop Heater.
Align cast iron with base holes.
Use 4pcs M6X15mm bolts and fix the Tank housing
to the base.
Tighten the bolts as shown below.
Step 2 – Attach Burner Assembly to Tank Housing
Put the Burner on the Tank Housing then attach with 4
3/16" bolts.
All manuals and user guides at all-guides.com
Fix the Regulator to the Tank Housing with each one of
one M5X10mm bolt and one M5 nut.
Step 3 – Emitter screen Assembly
Attach 3 60mm-long pins to the emitter screen. Tighten
with 3 M5 nuts.
Place Emitter screen on the Burner. Use 4pcs 3/16" bolts to
connect the Emitter screen to the Burner.Tighten the bolts.
5