Bosch FNM-420U-A-WH Guide D'installation page 9

All manuals and user guides at all-guides.com
Sounder Indoor |
Outdoor, uninterruptible
1 Notes
Notice!
Installation must only be carried out by authorized specialist
personnel.
Caution!
The products should only be assembled out of direct sunlight,
!
as this is the only way to ensure correct functioning and a long
service life.
Notice!
Batteries must not be disposed of in household waste. Please
take used batteries to the local collection points. See
www.boschsecurity.com/standards for further information.
2 Installation
See Graphics, page 4.
1. Open the Sounder Indoor using the tool supplied (1). Press
the point of the tool into the openings provided for it on
the housing.
2. Drill the required holes (2) on the rear side or underside of
the housing and feed the cable into the housing. For the
Sounder Outdoor, use PG cable glands for the cable feed
(not included in the scope of delivery). If the PG cable
glands cannot be used, please proceed as follows:
Hole diameter = cable diameter + 1 mm
3. Fit the rear of the housing on a level, dry surface using the
pre-punched and/or any existing bore holes (3) and a
minimum of two screws.
4. Wire up the sounder using the terminal block and connect
the battery. Push the loose battery plug into the specified
bushing (4) as far as it will go.
Bosch Sicherheitssysteme GmbH
Notes | en
2017.11 | 4.0 | F.01U.216.912
9