Publicité
Les langues disponibles
Les langues disponibles
Technical Information
On the right side of the telephone there is a switch for Flash time.
Flash time (100/300/600).
100 is the standard setting for most countries including the UK.
Troubleshooting
Check that the telephone cord is undamaged and properly
plugged in. Disconnect any additional equipment, extension cords
and other phones. If the problem is resolved, the fault is with
some other equipment. Test the equipment on a known working
line (e.g. at a neighbour's house). If the equi�ment �or��s there
then the fault is probably with your telephone line. Please report
this to your network operator.
The answer machine is not answering
- Check that the unit is switched on.
- Check that the telephone cable and the mains adapter are
correctly connected.
The answer machine does not respond to remote access
- Check that the telephone you are using to remotely access the
answer machine is a tone dialling telephone.
- Some telephones only emit a short tone beep when buttons
are pressed, and this may not be enough to activate remote
access. Use a separate tone transmitter in these cases.
- Also try holding the buttons down longer, approximately 1
second per digit.
I can't hear the outgoing message very well
- Record a new outgoing message.
- Speak closer to the microphone when recording. The microphone
is located under the handset on the front of the telephone.
The line is disconnected when someone leaves a message:
- An incoming message may be up to 120 seconds in length.
After this time, the call will be disconnected.
- If the caller pauses approximately 7 seconds or more, the call
may be terminated, since the voice control function believes
that the caller has hung up.
I only hear a tone sequence when I press the playback button:
- There are no incoming messages.
There are no incoming messages.
If the device still does not work, please contact the place of
purchase for service.
English
All manuals and user guides at all-guides.com
Publicité
