Panasonic ES4815 Manuel D'instructions page 5

P05-19̲ES4815̲EU.qxd 09.2.25 16:14 ページ 5
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet/Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Parts identification
(see fig. 1)
A Protective cap
B Outer foil
C Outer foil release button
D Foil frame
E Inner blade
F Foil frame release button
G On/Off switch
H Switch lock button
I Battery cover
J Battery cover release dial
K Cleaning brush
Replacing batteries
Before replacing the batteries, wipe
the shaver free of moisture to pre-
vent the inside from getting wet.
1. Turn the battery cover release
dial and remove the battery cover.
(Turn the dial to 90° in the coun-
ter clockwise direction and re-
move the battery cover.) (Fig.2A)
2. Insert the two AA (LR6) alkaline
batteries as shown in the figure.
All manuals and user guides at all-guides.com
3. Replace the battery cover with
4. After replacing the battery cover
For a better shave
Put a thin layer of shaving foam on
your face which works as a lubricant.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it may af-
fect the shaver's performance. If the
shaving head is clogged with foam,
simply rinse it under running water.
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (see fig.
3). Start out shaving by applying gen-
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
5
After checking that their polarity
matches that indicated behind the
shaver main body. (Fig. 2B) (If the
(+) and (–) poles are not inserted
properly, the motor will not oper-
ate.) Do not use a new battery
with an old battery.
the dial mark at open. Check for
proper sealing of the water-proof-
ing ring.
to the main unit, turn the dial mark
to close (Fig. 2C).