Publicité
Les langues disponibles
Les langues disponibles
Operation
WARNING!
carefully read and understand this manual and all of
its safety, operating and maintenance sections and
instructions, along with all of the decals on the
machine. Failure to follow these instructions can
result in serious personal injury.
Introduction
Read this Operation Section and the Engine Operator's Manual
before you start the engine. Then, take the time to familiarize
yourself with the basic operation of the tiller before using it in
the garden.
Find an open, level area and practice using the tiller controls
without the tines engaging the soil (put tines in "transport"
setting).
Only after you've become completely familiar with the tiller
should you begin using it in the garden.
Break-In Operation
Perform the following maintenance after the first five (5) hours of
new operation (see Maintenance & Adjustments Section in this
manual).
1.
Change engine oil.
2.
Check for loose or missing hardware on the tiller. Tighten
or replace as needed.
3.
Check transmission gear oil level. See the Maintenance &
Adjustments section.
Starting the Engine
Pre-Start Checklist
With the spark plug wire disconnected from the spark plug,
perform the following checks and services before each use:
1.
Read the Safe Operation Practices and the Features &
Controls Section in this manual. Read the separate Engine
Operator's Manual provided with the tiller.
2.
Put the wheels in the WHEEL DRIVE position (wheel pins
must be through holes in wheel hubs and wheel shaft).
WARNING!
in the freewheel position when the engine is
running. Always put both wheels in the wheel drive
position before starting the engine. Failure to
comply could cause loss of tiller control, property
damage or personal injury.
3.
Check the tiller for loose or missing hardware. Service as
required.
4.
Check the engine oil level. See the Engine Operator's
Manual.
5.
Check that all the safety guards and covers are in place.
6.
Check the air cleaner and engine cooling system. See the
Engine Operator's Manual.
10
All manuals and user guides at all-guides.com
Before operating your machine,
Never allow either of the wheels to be
7.
Fill the fuel tank with gasoline according to the directions
in the separate Engine Operator's Manual. Follow all
instructions and safety rules carefully.
8.
If necessary, Attach the spark plug wire to the spark plug.
Starting the Engine
WARNING!
To help prevent serious personal injury
or damage to equipment, put both wheels in the
WHEEL DRIVE position. Never have wheels in
FREEWHEEL position when the engine is running.
When the wheels are in FREEWHEEL, they do not
hold back the tiller and the tines could propel the
tiller rapidly forward or backward. Put the Forward
Clutch Bail in neutral (disengaged) positions by
releasing the lever.
WARNING!
Never run the engine indoors or in an
enclosed, poorly ventilated area. Engine exhaust
contains carbon monoxide, an odorless and deadly
gas. Avoid the engine muffler and nearby areas.
Temperatures in these areas may exceed 150° F.
1.
Complete the Pre-Start Checklist above on this page.
2.
Put the wheels in the WHEEL DRIVE position.
3.
Move the depth regulator lever all the way down to the
"travel" position, so that the tines clear the ground. To
change the depth setting, pull back on the depth regulator
lever (A) and lift up or down (B), then release the lever (C) to
secure in the desired position. See Fig, 5-1.
Depth Regulator Lever
A
Figure 5-1
4.
Release all of the controls on the tiller.
5.
Start the engine as instructed in the Engine Operator's
Manual.
5
B
Publicité
