Mityvac MV7201 Mode D'emploi page 4

8. Once the oil has been extracted from the crankcase, remove the expandable rubber plug from the reser-
voir tank; pour the oil from the tank into a suitable container, and dispose of the oil in an appropriate man-
ner. Rinse out the reservoir tank with clean solvent or engine degreaser. Allow it to dry thoroughly.
9. If you wish to use the Fluid Evacuator Plus to dispense oil, fill the cleaned reservoir tank with new oil and
simply switch the selector valve that is mounted on the side of the pump assembly to "DISPENSE".
10. Pull up on the pump handle and begin pumping until the engine crankcase is filled to the desired level.
11. Run the engine momentarily to circulate the new oil and then re-check the level.
Extracting From and Dispensing Fluid into Transmission Cases and Differentials
1. Follow Steps 1 & 2 above. (See Extracting and Dispensing Motor Oil into a Crankcase)
2. Remove the transmission fluid dipstick or fill plug.
In some applications this may require jacking or lifting the vehicle. Use appropriate safety stands to avoid
serious or fatal injury.
3. Select and insert the appropriate diameter dipstick tube into the dipstick fill hole until it reaches the bottom
of the transmission pan or gear case. Connect the main suction tube to the dipstick tube.
4. Insert the opposite end of the main suction tube into the 10mm x 90° tube connector on the top of the reservoir
tank. Take care that tube is in the connector all the way to prevent leakage.
5. Place the selector valve mounted on the side of the pump assembly to "EVACUATE".
6. Raise the pump handle on the reservoir tank until it reaches its highest limit. Pump the handle approxi-
mately ten times. The unit will begin to extract the transmission fluid from the transmission.
7. Once the transmission fluid has been extracted, remove the expandable rubber plug from the reservoir
tank; pour the transmission fluid from the tank into a suitable container, and dispose of the transmission
fluid in an appropriate manner. Rinse out the reservoir tank with clean solvent or engine degreaser. Allow
it to dry thoroughly.
8. If you wish to use the Fluid Evacuator Plus to dispense transmission fluid, fill the cleaned reservoir tank
with new transmission fluid and simply switch the selector valve that is mounted on the side of the pump
assembly to "DISPENSE".
9. Pull up on pump handle and continue pumping until the transmission is filled to the desired level.
10. Follow the operating instructions for your vehicle to properly check the transmission fluid level.
Extracting and Dispensing Coolant into a Cooling System
Never remove the cap from the radiator or expansion tank while the engine is at operating temperature. Al-
ways allow the engine to cool before removing the radiator cap or expansion tank cap. The cooling system
is under pressure. Failure to allow the engine to cool before attempting to remove the cap could result in
serious injuries.
Page Number - 4
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
All manuals and user guides at all-guides.com
Form 801672F