Publicité
Les langues disponibles
Les langues disponibles
S E T U P
1
2
•
Locate the joystick controller.
•
Slide the joystick controller into the arm rest tube (image 1). The length of the joystick controller
can be adjusted for comfort before or after secured
•
Secure the latch once the joystick is inserted to the desired length (image 2)
•
Align the arrows of the joystick connection cables and press them together to plug the joystick
controller in (image 3)
•
Rotate the coupling over the connection point to secure the connection point (image 4)
4
5
•
Locate the red connection points at the rear of the chair and connect the points together as
shown in image 4
•
This connection will connect the battery power to the control system
•
Adjust the footrest to the desired length by pressing down on the center button as shown in image 5
•
Pull the footrest into one of three locking positions (image 6)
NOTICE: Make sure the battery is connected to the system or the chair will not work (image 4)
12
3
6
S E T U P
•
Before sitting in the Power Chair, be sure the power button
is OFF and the rear brake levers are in the DOWN (locked)
position
•
VISTA offers the user 2 optional entry alternatives, direct
front entry or side entry
•
If you prefer a front entry, we recommend flipping up the
foot plate to create an easier sitting experience
•
DO NOT step on the footplate when entering or exiting the
VISTA as it may cause the power chair to move in an unsafe
manner
1
2
•
Joystick can be positioned on left or right arm rest
•
To change joystick position, first remove the joystick by
performing the opposite sequence of the steps above
•
Move the power cable to the opposite side and re-fasten
with plastic ties, be sure the cable is not interfering with the
folding or movement of the Power Chair
•
Connect the joystick
To enter on the side press
down on arm release button
as shown in image 1. Raise
arm rest back and away.
When seated, lower arm
rest back into position and
ensure it is locked.
13
Publicité
