Publicité
Les langues disponibles
Les langues disponibles
TYPICAL INSTALLATIONS
BH0001A
Housing mounted
to
-joists.
I
3A
Housing mounted to joists.
05A
Housing mounted anywhere
between trusses using
hanger bars.
PLAN THE INSTALLATION
Do not install above or
45º
NOT FOR USE IN
A COOKING AREA.
All manuals and user guides at all-guides.com
0002A
Housing mounted anywhere
between
using hanger bars.
Housing mounted anywhere
between joists using
hanger bars.
BH0006A
Housing mounted anywhere
between trusses using
hanger bars.
COOKING AREA
inside this area.
45º
Cooking
Equipment
Floor
INSULATION
(Can be placed
around and over
fan housing.)
-joists
I
FAN
HOUSING
*
Purchase
separately
The unit will operate most quietly and efficiently when located
where the shortest possible duct run and minimum number
of elbows will be needed.
Use a roof cap or wall cap that has a built-in damper to
reduce backdrafts.
Plan to supply the unit with proper line voltage and appropriate
power cable.
INSTALL HOUSING & DUCT
1a. Mount
housing
to joist or
I-joist.
Use pliers to
bend housing
TABS out to 90°.
Hold housing
in place so that
the housing
tabs contact
the bottom of
the joist. The
housing mounts
with four screws
or nails. Screw
or nail housing
to joist through
lowest holes in
each mounting
flange, then
through highest
holes.
NOTE: Mounting to
of SPACERS (included) between the highest hole of
each mounting flange and the I-joist.
MODELS QTR090LC • QTR110LC
QTRE090FLC • QTRE110FLC
4-IN.
ROUND
*
DUCT
4-IN. ROUND
*
ELBOW(S)
TABS
BD0001
SPACER
(use for mounting to
I
-JOIST (shown) requires use
OR
Page 2
ROOF
CAP
*
WALL
CAP
*
I
-Joist)
I-Joist
Publicité
