Publicité
Les langues disponibles
Les langues disponibles
Note: Please note that not all functions are possible in all
digital protocols. Several settings for functions, which are
supposed to be active in analog operation, can be done
under mfx and DCC.
Notes on digital operation
• The operating instructions for your central unit will give
you exact procedures for setting the different parame-
ters.
• The values set at the factory have been selected for mfx
in order to guarantee the best possible running characte-
ristics.
Adjustments may have to be made for other operating
systems.
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29/Bit 2 = 0).
14
All manuals and user guides at all-guides.com
mfx Protocol
Addresses
• No address is required; each decoder is given a one-
• The decoder automatically registers itself on a Central
• Name set at the factory: 403 003-7 LHAE
Programming
• The characteristics can be programmed using the
• All of the Configuration Variables (CV) can be read and
• The programming can be done either on the main track or
• The default settings (factory settings) can be produced
• Function mapping: Functions can be assigned to any of
time, unique identifier (UID).
Station or a Mobile Station with its UID.
graphic screen on the Central Station or also partially
with the Mobile Station.
programmed repeatedly.
the programming track.
repeatedly.
the function buttons with the help of the 60212 Central
Station (with limitations) and with the 60213/60214/60215
Central Station (See help section in the Central Station).
Publicité
