SLIM FIT
EN
Symptom
• When the unit starts up or runs, the
display
shows
protection).
The
automatically, with the display showing
E9 until the unit has a slant of less than
45º.
• Water is entering the cabin or is filtering
in from outside.
•
The equipment works but does not
cool.
* Suitable machinery must be used whenever it is necessary to extract or introduce
the circuit gas load, respecting the environment at all times.
All manuals and user guides at all-guides.com
E9
(compressor
unit
goes
• Unit or card slant of 45º or over.
off
• Valves or wastewater pipes obstructed.
• EPDM seal poorly attached or defective.
• The cabling outputs which protrude from
the lower cover of the blower and coil
cabin are not properly sealed.
•
Too much or too little load in the
circuits.
• Electro wire clamp inverted.
• Dirt in the capacitor.
• Electro defective.
• Blockage in the circuit.
22
Cause
®