Makita LC1230 Manuel D'instructions page 8

ENGLISH
(Original instructions)
1 Hook
2 Bolt
3 Lock-off button
4 Lever
5 Handle
6 Switch trigger
7 Graduation
8 Indicator
9 Vise stop
SPECIFICATIONS
Model
Blade diameter .................................................................................................................................................... 305 mm
Hole (arbor) diameter ......................................................................................................................................... 25.4 mm
-1
No load speed (min ) ............................................................................................................................................. 1,300
Dimensions (L x W x H) .........................................................................................................516 mm x 306 mm x 603 mm
Net weight ............................................................................................................................................................19.3 kg
Safety class ............................................................................................................................................................
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
8
All manuals and user guides at all-guides.com
Explanation of general view
10 Dust box
11 Wrench holder
12 Base
13 Center cover
14 Hex bolt
15 Socket wrench
16 Blade guard
17 Shaft lock
18 Carbide-tipped saw blade
115 mm
90 mm
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
ENE008-1
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
ENF002-2
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future refer-
ence.
19 Spindle
20 Inner flange
21 Outer flange
22 Vise plate
23 Vise nut
24 Vise handle
25 Limit mark
26 Screwdriver
27 Brush holder cap
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85 mm
LC1230
/II
ENF100-1
GEA010-1