Gardeo GDCBT41 Guide De L'utilisateur page 31

NOTE!
Press the quick release button or pull emergency release flap in the event of emergency. (Fig. 2-2C)
Fig. 2-1A
S
TOPPING
• Decrease engine speed and run at an idle for a few minutes, then turn off ignition switch.
A cutting attachment can injure while it continues to spin after the engine is stopped or power control is
released. When the unit is turned off, make sure the cutting attachment has stopped before the unit is set
down.
C A
ARBURETOR DJUSTMENT (Fig. 3-1)
Never start the engine without the complete clutch cover and tube assembled! Otherwise the clutch can
come loose and cause personal injuries.
In the carburetor, fuel is mixed with air. When the engine is test run at the factory, the carburetor is basically
adjusted. A further adjustment may be required, according to climate and altitude. The carburetor has one
adjustment possibility:
IDLE SPEED ADJUSTMENT
• Check that the air filter is clean. When the idle speed is correct,
the cutting attachment will not rotate. If adjustment is required,
close (clockwise) the idle-screw, with the engine running, until
the cutting attachment starts to rotate.
• Open (counter-clockwise) the screw until the cutting attachment
stops. You have reached the correct idle speed when the engine
runs smoothly in all positions well below the rpm when the cutting
All manuals and user guides at all-guides.com
WARNING!
M
AINTENANCE
WARNING!
- 31 -
Fig. 2-2B
DANGER!
DANGER!
Fig. 2-2C
Fig. 3-1