Publicité
Les langues disponibles
Les langues disponibles
A
T
H
SSEMBLE
HE
ANDLES (Fig. 1-1)
•
Loosen the 4 bolts on the upper shaft
•
Insert the handle
•
Push on the handles as desired
•
Tighten the 4 screws with the 5mm Allen Key.
R
C
EPLACE THE
UTTING
•
Ensure the brush cutter is switch off and be sure the engine full
stopped.
•
Insert a prevent rotational wrench or equivalent into the back
shield and the adaptor semicircle hole to prevent the output shaft
from turning.
•
Loosen the nut with the socket wrench (T-Wrench) by turning
counterclockwise (view from top), then remove spring washer,
washer, cover cap, spacer and cutter blade from the output shaft.
•
Replace the cutter blade, install the blade, by aligning the center
of the blade with the shoulder on cover spacer A.
•
Install spacer B, the cover board, the washer and spring washer,
then tight the nut.
•
Remove the prevent rotational wrench or equivalent from the
back shield and adaptor.
I
T
NSTALL THE
RIMMER
•
Ensure the brush cutter is switch off and be sure the engine full
stopped.
•
Insert a prevent rotational wrench or equivalent into the back
shield and the adaptor semicircle hole to prevent the output shaft
from turning.
•
Loosen the nut with S5 wrench by turning counterclockwise (view
from top), then remove spring washer, washer, cover cap, spacer
and cutter blade from the output shaft.
•
Insert the shield on the fixed bracket, tighten the screw.
•
Tighten the Spool & Line Assembly on the machine head bolt by
turning clockwise.
All manuals and user guides at all-guides.com
A
P
SSEMBLY
B
LADE (Fig. 1-2, 3)
H
EAD (Fig. 1-2, Fig. 1-4)
- 29 -
ROCEDURES
Fig. 1-1
Fig. 1-2
Fig. 1-3
Publicité
