Haier HW70-B14266 Mode D'emploi page 10

Care and cleaning
Water inlet valve and inlet valve filter
To prevent blockage of water supply by foreign substances,
clean inlet valve filter regularly.
Period of disuse
If the appliance is left idle for a longer period, pull out
the electrical plug (1) and turn off water supply (2).
Open the door to prevent formation of moisture and
odours. Let door open while not used.
Before next usage check carefully power cord, water inlet
2
and drain hose. Make sure everything is properly installed
and without leackage.
All manuals and user guides at all-guides.com
18 19
Display code
Code Cause
Auto Automatic load detection.
1:25 Remaining wash cycle time.
19:30 Remaining wash cycle time.
Lock Door is locked.
End End of wash cycle.
E1 Drainage error, water is not
fully drained within 6 minutes.
E2 Lock - error.
E4 Water level not reached after 8 minutes.
Drain hose is self-syphoning.
E8 Water protective level - error.
F3 Temperature sensor - error.
F4 Heating error (Appears at the end of a cycle). Contact the After sales service.
F7 Motor - error.
Fb Water overflow .
FA Water level sensor error.
FC Electronic control - error.
Unb Unbalanced load - error.
Warning!
Code Fb: Water-overflow protection is placed on deepest part of appliance. In case of leacka -
ge all functions will be shut down automatically except drain pump which will be activated for
safety reasons.
Troubleshooting
Solution
Wait until programme cycle time
is displayed.
Refer to additional symbol.
End is likely delayed - refer to symbol.
Wait, operational door locking.
Clean pump filter.
Check drain hose for blockage
and proper installation.
Shut the door properly,
Make sure that tap is fully opened
and water pressure is normal.
Check drain hose installation.
Auto released otherwise contact the
after sales service.
Contact the After sales service.
Contact the After sales service.
Close tap immediately.
Contact the After sales service.
Contact the After sales service.
Contact the After sales service.
Cut power supply. Check and
balance laundry load. Try to run a
spinning programme