Publicité
Les langues disponibles
Les langues disponibles
PREPARATION - BEFORE INSTALLATION:
1. This product should be installed with proper installation tools.
2. Install this product while observing all warnings and precautions
stated in this instruction booklet.
3. VERY IMPORTANT: Thoroughly wash vehicle with Soap and
Water.
4. Parts storage should be flat at room temperature and in a clean
dry place. Care should be taken to avoid a dusty environment.
Rear Bumper Applique
1 Alcohol
Thoroughly wash vehicle with a soft lint-free cloth. Wipe the panel
where the Bumper Applique will be installed with alcohol wipes.
Allow the area to dry completely.
Premask / Handling Tab
Bumper Applique
3
Separate Liner
Remove liner from Bumper Applique as shown. To prevent
contamination, limit touching adhesive side of the Bumper
Applique by using handling tabs.
Spray alcohol, soap and water application solution on adhesive
side of applique.
DESCRIPTION
Rear Bumper Applique
Bumper Applique
Liner
Premask
ISSUE
00
Notes to the Installer
1.
Read the entire installation instructions prior to beginning the
installation of the accessory.
2.
Ensure that the vehicle is properly protected in the area that
the accessory is to be installed.
3.
To prevent vehicle damage, never place tools on top of painted
surfaces, seats, dash pad, console or floor carpet / mat.
4.
Always wear appropriate safety gear to include gloves and eye
protection when required.
2
Dry Fit
**Confirm that the rear bumper appliqué does not obstruct any of
the Reverse Automatic Braking sensors.
Align the Bumper Applique into position using the handling tabs,
door notches and panel edges as references. Locate center notch
in the applique directly under the notches in bumper and align as
shown above.
Liner
4
Spray Bumper Surface
Spray the bumper surface with the application solution.
DATE
SUBARU OF AMERICA
9/6/22
PAGE
2 / 4
Publicité
