Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUTIONS
WARNING
If the water has been damaged or exposed to fire or sooting
or if any part has been underwater do not use. Immediately
call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas
control which has been underwater and to clean the heat
exchanger assembly and water valve.
FILLING
Before proceeding with operation of the water heater make
sure that system is filled with water.
-
Make sure drain is closed, see figure 8, below.
-
Open a nearby hot water faucet to permit the water to
fill the heater and piping.
-
Close the hot water faucet after the water flows freely
and all air has escaped from system.
-
The water heater is now ready to be lit.
Figure 8
SERVICE HINT
The strainer (screen) in the water valve, located in the inlet
of the water valve, may require occasional cleaning due to
foreign material in the water supply. This will restrict the
flow of may affect heater operation and prolong filling time.
To inspect the strainer close the cold water supply valve
ahead of the heater, disconnect S-bend from inlet of water
valve, and remove strainer from inlet. Clean if required,
replace strainer in inlet to water valve, reconnect S-bend
and turn on water supply.
Light the water heater in accordance with the instructions
on the Lighting and Operating Plate on the water heater.
For your convenience, the instructions are repeated below.
All manuals and user guides at all-guides.com
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information, first section of the
Lighting Instruction Plate on the cover.
2. The main manual gas valve must be closed (turn valve
handle clockwise
) and the gas valve OFF button
depressed
. See figure 9.
3. Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow "B" in the safety information
given above on this plate. If you don't smell gas, go to
next step.
4. The pilot burner is located behind the peephole located
in the front center of the jacket directlybelow this
instrution plate.
5. Open main manual gas valve by turning valve handle
counterclockwise
6. Depress PILOT button
PILOT IGNITER button
repeated.
7.
Observe pilot flame though peephole. The PILOT button
-
should be held down at least 10 seconds with
pilot burning. When the PILOT button is released the
pilot should continue to burn.
-
If the PILOT button does not pop up when released
stop and immediately call your service technician or
gas supplier.
-
If the pilot will not stay repeat lighting procedure steps
1 through 8.
-
If the pilot will not stay lit after several tries, depress the
OFF button
, turn the manual gas valve handle
clockwise
to OFF position and call your service
technician or gas supplier.
8. Depress the ON button
when water is drawn at arate greater than the threshold
flow rate (see manual)*.
Note: If main burner should fail to ignite make sure pilot is
burning. If not repeat lighting procedure steps 1 through 8.
TO TURN OFF GAS TO APPLIANCE
1.
Depress OFF buton
by turning handle clockwise to OFF position. See figure
9.
*see Water Flow Selector section.
.
and light pilot by pushing
. This may have to be
. The heater will now fire
and close the main gas valve
7
Publicité
