Kohler K-10121 Guide D'installation page 3

Apply
plumbers
putty.
Setscrew
Showerhead
1. Install the Showerhead
NOTE: The shower arm with wall flange are not provided.
Remove the existing showerhead and shower arm, if applicable.
Install the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the wall flange according to the manufacturer's instructions.
Place the wall flange onto the long end of the shower arm just
below the threads, as illustrated.
Apply thread sealant tape to the threads of each end of the
shower arm.
Place the shower arm in the shower ell.
Carefully tighten the shower arm onto the shower ell with a clean
strap wrench.
Press the wall flange against the finished wall.
Secure the flange to the shower arm by tightening the setscrew
with a hex wrench.
Remove any excess putty.
Turn on the water and allow water to flow through the shower
arm to flush the system of any debris.
Turn off the water.
Thread the adapter onto the showerhead until hand-tight.
Hand tighten the showerhead to the shower arm.
Kohler Co.
Shower Ell
Wall Flange
(Not Provided)
Shower
Arm (Not
Provided)
Adapter
3 1046289-2-A