MrCool DIY Serie Manuel D'utilisateur page 10

• Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the SWING /DIRECT
button to set the di rection (vertical angle) of
airflow.
1. Press the DIRECT button once to activate
the louver. Each time you press the button,
it will adjust the louver by 6°. Press the button
until the direction you prefer is reached.
2. To make the louver swing up and down
continuously, press SWING button
Press it again to stop the automatic
function.
Setting horizontal angle of air flow
and manually adjust it to your preferred direction.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver
at an extreme vertical an angle for long periods of
time. This can cause water to condense on the
louver blade, which will drop on your floor
or furnishings. (SeeFig. 2.2)
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air flow.
Do not move vertical louver by hand. This will cause
the louver to become out of sync. If this occurs, turn
o
then restart the unit. This will reset the louver.
Page 9
All manuals and user guides at all-guides.com
Fig.2.3)
Fig. 2.2
CAUTION
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. 2.3
Caution: Do Not keep louver
at an extreme angle for long
periods of time. This can
cause water condensation
to drip on your furnishings