Assembly And Operation; Applications; Prior To Operation - Hitachi CM 4SB2 Instructions De Sécurité Et Mode D'emploi

English

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting and scribing of concrete.
Cutting and scribing various types of stones.
Cutting and scribing various types of tiles.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle
while the switch is in the ON position, the power tool will start operating immediately
and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short as
practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause overheating, resulting in a serious
hazard.
5. Mounting the diamond wheel
For details, refer to the item "Mounting and dismounting the diamond wheel".
6. Confirm that the cutting depth adjusting lever is securely clamped.
12
WARNING:
Damaged cord must be replaced or repaired.